Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a plain E1 circuit My e1 interfaces are configured as Clock source & line.On my serial 1/0:1 interface do i also need to configure clocking & line clock & is PPP encapsulation required on the Serial Interfaces.Many ThaksLarry_s
if a rip enabled primary interface goes down and is backed up by a dialer 1 Floating static route with an admin distance of e.g 200 can a second Dialer 2 be configured to connect to the same location via a second floating static route e.g admin cost ...
I need to establish a E1 to E1 link across a Circuit described by the Service provider" as a plain circuit with no framing and the clocking should be configured as master slave. Linecode is HDB3." Do i need to configur a Channel group and if so how s...
I have a remote office with a 2600 LL & ISDN backup. Using dialer groups. I need the router to backup to the primary site via isdn to corporate RAS, however in the event of a major primary site diaster where by RAS is not responding i need to ISDN di...
Two switches were connected over a X-Over cable. I have a Up / Down on the Uplink Ports. Is there any way of determining which switch end is technically loosing recieve or losing transmit for any of the debug Info.i.e if i removed the X-Over from 1 s...
PareshI will be submitting this configuration This evening so based on your assistance I believe all should go well. Pleased see attachment of proposed config for far end. Any errors please feel free to advise.Many ThanskLarry_s
PareshRe the E1 circuitSo is there any requirement to setup Framing on the interface or will the default crc4 be applicable or should it be set for unframed.Many ThanskLarry_s
PareshI Think I did not post my last mail.YesThe remote site is backing up the FR circuit with a dialer interface. In the event of the Dialer connection not establishing there is a wish for an automatic ISDN Call to and ISP and establish a VPN tunnel...
PareshActual design Problem Currently Primary FR is backup By dialer0Customer is looking for VPN establishment to primary location in the event of dialer non connection.Any Suggestions.Many ThanksLarry_s
