Acerca de mina_raouf

mina_raouf · 12-09-2019

HelloI have a cisco controller 5520 with more than 300 access points joining it, I found that most of the access points like 250 out of 300 are working on the maximum power level 1 on 5g band only, while on 2.4 bands the power level is within normal ...

mina_raouf · 07-04-2019

Hello,I have a deployment of Cisco 2802I access points, WLC is 5520 running software image 8.5.140.0, and I have a problem where some users suddenly got disconnected and got the yellow exclamation mark on the connection status This issue affects some...

mina_raouf · 12-04-2018

Hello, my client was having a legacy wireless network in a warehouse environment with ceiling height about 10m high , the legacy AP was 1242 with external antenna where the signal coverage was good and never reported coverage problems, however aft...

mina_raouf · 07-25-2018

Hi All, I have access points in 2 sites that are joining a regional primary controller and each ap is a member of a certain ap group we configured a secondary controller to those APs that is located in another physical location "not in HA pair" ...

mina_raouf · 05-22-2018

is it mandatory for the AP fall back option to work to have all the controllers in the same mobility group or not ? Noting that the controllers are not on the same site and they are physically separated in different sites and I am not caring about s...

mina_raouf · 12-10-2019

The wireless design was designed on -67db during the predictive survey, the APs were also placed on the lowest power levels (10W) during the survey "DCA and TPC will be setting the power to power level 1 as it is not seeing the 5GHz neighbors close ...

mina_raouf · 12-10-2019

Till now (this is a new implementation) nothing was reported as slowness or bad performance, but it is a bit confusing for me why the access points are working on the highest power level although the distance between access points are not that far

mina_raouf · 12-09-2019

Hi The DCA is enabled on both band and also set to auto, I am using channel bonding of 40Mhz on the 5g band

mina_raouf · 11-21-2019

we are facing a similar issue but with flex connect deployment, the access points use to cache wrong mac address of the gateway router so clients are disconnected disabling the arp caching command is not working as it requires a higher IOSversion on ...

mina_raouf · 12-04-2018

Hi, I already adjusted it from -10 to 10 but same issue

Miembro desde	‎05-02-2017 02:52 PM
Fecha de la última visita	‎12-16-2019 03:24 AM
Mensajes publicados	37
puntos útiles recibidos	5

Estadísticas de usuario

Actividad del usuario

Access point power level is maximum with good RSSI

Users disconnects randomly with yellow exclamation marks

issues after Replacing 1242 with new 2802 APs

Access point abnormal behaviours during a fallback

Ap fall back option

Re: Access point power level is maximum with good RSSI

Re: Access point power level is maximum with good RSSI

Re: Access point power level is maximum with good RSSI

Re: wireless users ARP entry will

Re: issues after Replacing 1242 with new 2802 APs