Hi allI have this configuration :switch catalyst 2950 (SI) with vlan 2 and vlan 3 and one port on native vlan (vlan 1) which is the trunk port. Trunk port is connected to the inside interface of my pix 515. On pix i create vlan2 on physical interface...

Hi all,I looking for documentation about QoS in a cisco 1761 router. I'll find the Autoqos command (vith voip). My question is probably dummy but i don't find a documentation which show the command which is used by autoqos voip. I explain : i looking...

Hello, I had try to use the static command with my pix and with the help i see the keyword "dns". I had looking for documentation and exemple for this function but i haven't find documentation.If someone know this function i'll by happy to read this ...

Hi all,I have a pix 501/515. When a packet arrived into my pix, i must change its destination's address. If that possible with a nat/global command ? if my packet is [source=192.168.3.1|dest=200.0.1.1] i'll obtain [source=192.168.3.1|dest=10.0.1.1].T...

Hi,I must mount a vpn between two client. The two Client has the same subnet (10.0.1.0/24). So i must find a solution to know what vpn my packet must take (I hope that is clear :) . I tried this :each client as a virtual ip (for exemple 20.0.1.0 and...