Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I have a question about the Cisco Meraki CW9176I and CW9172I access points. While reviewing the installation guide for both models, I found the supported operating capacities based on power source and Ethernet speed, but I couldn't find a...
I have a Catalyst IE-3300-8P2S where, when I try to apply the "auto qos trust cos" command to an interface, I get the message "Autoqos-Enhanced commands are not supported." My question is whether the Auto QoS function is not supported by Catalyst IE-...
Hi,I've been performing failover testing on a physical stack of two switches (C9300-48U and C9300-24U). During these tests, I observed certain specific behaviors that I would like to confirm are expected based on Meraki's design when running these ty...
I have a physical stack of two C9300 switches. I want to configure Link Aggregation of ports from both switches to another upstream switch, but when I try to configure it, it doesn't allow me to aggregate two interfaces from different switches in my ...
I will be deploying a C9300-48U-M device that will have the C9300-NM-8X-M uplink module. The SFP I was provided with is an SFP-10G-SR. I have a question regarding this SFP, as the switch datasheet doesn't mention its compatibility with the device. In...
Partly yes, since I have a link aggregate consisting of one port on the active switch and another on the member switch acting as an uplink. But the question remains as to why the management IP address isn't reached when one of the two switches is dow...
Are you stating that when the failed switch comes back online and joins the stack that the stack uplinks don’t pass packets? - Yes, when both switches are already in the stack (after one goes offline) communication through the stack, both incoming a...
The problem, as you mentioned, was that I had different port configurations. After having the same configuration, I was able to enable the Link Aggregation option for the desired interfaces. Thank you.
No error appears, but when simply selecting the desired ports for the different members, the "Aggregate" option in the Switch ports section is still blocked.
