Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Working on a large workflow and the WorkFlow Designer keeps redrawing the workflow (not in a good way).After changing connections all blocks are redrawn and there is no logic anymore. Spending 3 minutes every time to manually move all blocks I would ...
UCS Director 5.2.0.2When running a workflow with the task: Setup PXE boot we get the message:Failed to setup PXE Boot With BMA Selection.IP Address pool exhausted, All addresses in use But I cannot find any pool that is exhausted.All previous flows h...
I cannot find what the physical accounts minimal rights requierments are?This is for UCS Director 5.0 / 5.1.For example what needs an account for connectiong a Nexus switch need?Does is always need full rights, or can we create an account with only l...
Wow, you were absolutly correct. Cleaned all (only a few) PXE requests and its working again.Something went wrong with the rollback probably. I clicked everywhere in search of the pool that was exhausted even in the UCSM account but not on the POD. T...
