About richardp

Specific IP address for user · 11-19-2003

I am trying to configure a Cisco 3725 to give a particular dialin user a specific IP address and give all other users an IP address from the ip address pool. I have the ip address pool working but don't know how to give the particular user a specifi...

richardp · 06-04-2003

Can you forward udp broadcasts to a subnet (rather than a host) using the ip helper-address command?I have an application that relies on UDP broadcasts on UDP port 6614. I want these broadcasts to go to any device on a certain subnet (the subnet is ...

Re: Specific IP address for user · 11-19-2003

How do you put the ip address in the profile? Is that framed-address?

richardp · 06-09-2003

I tried using the broadcast address (172.17.255.255) as the helper address but I did not see any UDP traffic being forwarded. If I used the IP address the VPN client gets from the vpn pool (172.17.1.5), I could see lots of UDP traffic. I also tried ...

richardp · 04-28-2003

Are you using PAT (single outside address)?If so, v6.3 now supports ONE outbound VPN.PAT for ESPPIX Firewall Version 6.3 provides the ability to PAT IP protocol 50 to support single IPSec user outbound access.To support this feature, the fixup protoc...

richardp · 04-28-2003

There is no traceroute command on the PIX.

richardp · 04-28-2003

Unless you add an acl allowing access to the inside host, outside hosts cannot access it.

Member Since	‎03-28-2003 11:32 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	8

User Statistics

User Activity

Specific IP address for user

Forward udp broadcasts to subnet

Re: Specific IP address for user

Re: Forward udp broadcasts to subnet

Re: VPN transparent tunneling

Re: Traceroute

Re: confused by NAT