Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi team,
Can you help me with the AC power cord compatibility matrix for the WLCs for C9800-L-F-K9 and CW9800M?
Are the power cords CAB-AC-C5-C14= and CAB-AC-C5-C14CNKR= compatible?
Hi all,
We have a setup with 9800-F-K9 WLC and around 23 C9130 Aps registered to the WLC.
Most the APs acquire the IPs through DHCP. But Few APs doesn't fetch the IP address. But just when a console cable is connected to the Aps console port without...
Hi,
Does the AP AP2802I and C9130AXI use the same bracket?
I have ordered AIR-AP-BRACKET-2 which is yet to be delivered.
However, I have the bracket (as in the attachment) which i use for 2800/3800 APs. I understand they are AIR-AP-BRACKET-2.
Can t...
Hi all,
We have CISCO C9800-L-F-K9 in our network running on version 17.06.04 with 60 number of C9130AXI APs registered to it.
Similarly, we have the around 10 of same model of WLCs and version at different locations.
But the first said one WLC i...
I have the below out put for the sh ap ethernet statistics from the 9800 WLC.
AP Name : WAP001
Interface Name Status Speed Duplex Rx Packets Tx Packets Discarded Packets---------------------------------------------------------------------------------...
WLCs will be connected to APC PDUs. In that case, CAB-AC-C5-C14= and CAB-AC-C5-C14CNKR= are compatable?
Also, I couldn't find any documents related to this. Could you please share.
Hi all,
Can someone say if the issue is resolved? If so what was the solution?
I am facing the same issue that where we have ethernet and console cable coming from the cisco AP to the patch panel. But when the console cable is disconnected at the AP ...
For manually loading the firmware, I need to telnet or ssh to the AP.But the Ap is not taking the IP itself.If I use a console, then immediately as soon as console cable is connected, the Ap will acquire the IP and register to WLC.
