Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I'm trying to figure out why an ISR 4451 connected to the Internet has chosen a Stratum 2 NTP server over a Stratum 1 (212.26.18.41); when a 3750 connected to the Internet at another site has chosen the same Stratum 1 server successfully. S...
Hi all,We are piloting wired 802.1X but have hit a snag - FlexConnect AP switchport configuration requires the port be configured as trunk, with the native VLAN for management and access VLAN(s) for client data.I know 802.1X cannot be configured on t...
Thanks Jan.Yes I made that mistake once on my lab setup, and it reconfigured the trunk uplink to the router and so I lost connectivity to it - had to fix via console
Hi Jan,Tried using macros based on MAC addresses but they still weren't triggering, TAC suspected a bug with IOS version 12.2(55)SE5. They suggested upgrade to IOS 15 however then we run into bug CSCta05071 relating to CoA for wired 802.1X.What IOS ...
Hi Neno,After several TAC cases to try and get smart ports working, it turns out smart port macros aren't supported for FlexConnect/HREAP access points; only local mode access points.So the only options are to change away from FlexConnect, tag the na...
Thanks Neno!Number 1 isn't an option for our remote branches (where we need 802.1X and port security the most when APs are exposed).I'll have a read about smart ports.Are you able to provide a configuration example for multi-host mode with MAB that w...
