Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Please could someone tell me how to configure a C9500 switch interface that is named Twentyfivegige as a 1G mode uplink to a ISR 4351 router. media type is fibre therefore is it just a case of using a 1G SFP or is configuration requiered on the ...
Hi Forum, I have a C9300-48U-E with a NM x8 that supposedly supports an SFP for a 1Gb interface, the SFP (GLC-LH-SMD - 1000BASE-LX/LH (1Gb) I'm using is recognised by this 10Gb module, but the interface name is Tengigabitethent1/1/1.Has anyone experi...
On the same switch is it possible to configure that one user from a source authenticates to a tacacs+ server and then another user from another source authenticates to a different tacacs+ server, that is for each user an authentication/authorization ...
Hi,Can someone direct me to the cisco documentation that outlines the configuration on switches for aaa/tacacs+ to ISE using CHAP.Many thanks in advance
Hi, can anyone advise on the ME3400E switches handling of incoming packets that are DSCP marked, using CBWFQ, as to if by default the marking is trusted or if reclassification and re-marking is needed. I have read several blogs that suggest both met...
Hi Leo, yes that is the conclusion i'm coming to as the 1Gb SFP was recognised under the TenG interfaces Many thanks for your help and confirmation RegardsColin
Hi Arne, Your understanding is spot on, and I think I have to accept that this action of authentication is not achievable in the way I have to do it. Many thanks for your response been very useful.
