Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to set up a new C1300-12XT-2X switch. This is going into a small rack in my homelab. I have configured the device with a static IP address on my management VLAN (VLAN 10), however I can only access the management web interface when I als...
Thanks everyone, you all nailed the solution. The default gateway was the auto-configured gateway from the OOB port on VLAN 15. Once I configured a static route for 0.0.0.0 through the VLAN 10 gateway, all was working again! In retrospect, I shoul...
The part number is 'RCKMNT-1RU-1K='Specifically, this is what I ordered: https://www.provantage.com/cisco-systems-rckmnt-1ru-1k~7CSC639L.htm. Googling that part number will show some hits elsewhere too. They all show up as special orders though, ex...
It looks like these are finally starting to show up in the market. I ordered a pair from Provantage, and while they are listed as a special order, the order went through and they showed up in a little over a week. The price was as listed on their w...
Part number seems to be 700-131287-01, but I still can't seem to find these for purchase anywhere. Can we buy these if we contact Cisco directly? Here's a photo from a message that was posted earlier and mysteriously deleted.I made my own flush mou...
Are these brackets available yet? I just bought a CBS250-48P-4X that needs to be flush mounted (the rack door won't close otherwise, at least not with any cables/SFPs plugged in). I tried searching for "RCKMNT-1RU-1K=", but didn't get any hits.
