Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,How do I limit broadcast/mulitcast traffic on a switchport to e.g. 5000 pps ? I don't want the port to shut down, just block or drop broadcast traffic that exceeds 5000 pps Best regards,Jesper
Hi All,I have a problem downloading software and device updates for LMS 4.0.1.In the psu.log I get the following:[ Mon Nov 26 12:51:51 CET 2012 ] INFO [SwUpdateAction : getUpdatesFromCCO] : Validated Cisco.com credentials..[ Mon Nov 26 12:51:51 CE...
Hello all,I have a problem discovering some ASA firewalls on a network. I have several ASA firewalls on this /24 network, but some of them I can't discover e.g 149.x.x.107 is discovered ok, but 149.x.x.20 I can't discover. It seems that it's not even...
Hi,I have a problem when doing this report. If I do a device credentials report on a user defined group (40 devices) 11 of these devices fails to connect via SSH. I can make an SSH connection to all 11 devices from the CiscoWorks server, but 11 devic...
Hi all,I have a problem with the Campus Manager (version 4.1.0). After a data collection i try to se the result but get the following error:Report could not be found. I have tried to restart the ANI server, but same result. I have also tried to reini...
Hi Alain,I know what kind of traffic that causes this multicast storm. It's LLC traffic caused by a spanning-tree fault in the network.I have attached a wiresahark trace that shows the LLC multicast storm. The trace taken with an older wireshark vers...
Hi Alain,There is only one uplink trunk to the switch (Gi0/2)I expected that both ports Gi0/1 (WAN port), and Gi0/2 (Uplink port) would block incomming broadcast and multicast traffic that exceeds 5K pps.Regards,Jesper
Hi Alain,According to the log it's a multicaststorm that is detected.I have configured stormcontrol on both interfaces (uplink to the switch and towards the WAN:interface GigabitEthernet0/1 description data_towards_WAN switchport mode access storm-c...
Hi Alain,According to my calculater it's 5 minuts and NOT 5 sec.from 04:28:39 to 04:33:43 = 5 min.and 4 sec.Dec 18 04:28:39: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to downDec 18 04:28:40: %LINK-3-UPDOWN: Int...
Hi Alain,According to Cisco:Storm control uses one of these methods to measure traffic activity: •Bandwidth as a percentage of the total available bandwidth of the port that can be used by the broadcast, multicast, or unicast traffic •Traffic rate i...
