Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I'm kinda to my wits end about this one, as I do know that NTP can be setup when you use express setup when the switch is new out of the box.
However I can't find any source or material to change any of the configuration, like NTP, when the d...
Hi all,
We are using FPR1010's on remote sites and 9300 or 9200 series switches. Firepower runs Asa code 9.18.3.56
Today the 9300 hiccupped and kept thinking the interface eth1/2 was up on the standby firepower, however on the firepower side it's ad...
Hi all,
First and foremost apologies if this doesn''t belong here.
But I was wondering what the HA_EM-6-LOG: catchall XXXX messages are for on a 9800 WLC.
I''ve been trying to get messages over to Graylog but it seems the current setup contains no me...
Hello Balaji,I get what you're saying but that does not describe my particular situation.
I know Express setup is supposed to be used when you first initialize the device, what about it being in production and one wants to adjust say hostname, dns or...
Hey,
The full model is: IE-1000-8P2S-LM
And I get what Balaji is saying, but that is before using it in production.This switch (and multiple at that) is already in production for a long time.
I've been able to get our WLC to log to Graylog after some trial and error, but it's just these messages now and it seems to be okay, but I'd need to dig deeper into getting AP logging to Graylog.Although me adding those logs, might slow down the Gra...
I will check this tomorrow in a test environment if I have time.
Design wise and for backup reasons cable wise, we wanted to have separate portchannels for both nodes.
@MHM Cisco World @Ruben Cocheno As you've both replied the same answer, I tagged you both.
This is live config:
interface GigabitEthernet1/0/21description FW2-Eth1/1switchport trunk allowed vlan 1-3switchport mode trunkchannel-group 2 mode active
!
i...
