Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I feel like this should be a relatively straightforward question but I can never find a clear answer so maybe it depends on the environment. In our set up we have a combination of netgear gs724tpv2 and Cisco 2960x. It's a very simple environment we o...
So this is a topic that's been mentioned time and time again I'm sure but i wanted to get a bit more specific to my situation. We're replacing our core switch with a C9300 (we currently have a 3750). We have a pretty simple network. Any desk with a c...
So in our environment we have a cisco and netgear devices. Specifically 2960x and gs7xxtpv2(netgear). Our core 3750 is using rapid pvst (it shows up as rstp) and all of our netgear devices are set to rstp. We only have 2 vlans so it's a rather small ...
I'm going to be setting up new Meraki MX95 with HA set up. So here's ideally how the connections will beThis is based off Meraki Documentation on itI've set up a test network to download firmware and to test the failover. Right now, we have a single ...
So using a cisco catalyst 2960x during a network outage, I'm trying to connect via console to switch but old IT guy didn't note the password. I can type just fine via console but when I unplug > plug in > press and hold mode until I see "console usb ...
@balaji.bandi so I'm not sure why it was set up this way but on vlan 1 it seems to use just the default /16 subnet so if i try to make any other vlan and provide an SVI, as you said, I'll get an error that it overlaps. It seems I would need to reconf...
So right now we're using ubiquiti APs specifically UAP-AC-PRO and u6-LRs. Though we're going to migrate to Meraki APs. We only have 1 SSID but multiple VLANs 1, (soon to be vlan 10) and vlan 100 and I'd like to put the APs themselves on their own VLA...
@angela683huey Thank your for your suggestion. I would imagine, I'd need to set up IP addresses for the SVIs for VLAN 10 20 and 3 on the core switch such as VLAN 20: 172.31.20.1/24VLAN 3: 172.31.3.1/24 < Our Access Points are all configured with a 1...
So i was able to switch the core switch over to rapid pvst with no issue. Unfortunately that didn't resolve the map flapping notifications. I read somewhere that it can be normal as it might be users roaming from one AP to another. But we virtually h...
Will do. I'm hoping it's just a bit of a weird misunderstanding. Like on our core cisco switch, "show spanning-tree" shows "rstp" but the only options are mst, pvst and rapid-pvst. And testing it on a spare cisco/netgear switch, changing the cisco to...
