Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We added an ASA 5510 to a subnet 10.10.1.x, gave the ASA ip address of 10.10.1.10 We want to isolate traffic from server 10.10.1.5 from the rest of the subnet. But once we connect the ASA to the switch it takes all traffic from 10.10.1.xx subnet.How ...
I am trying to create a keepalive using HTTP-Headport 443path = /status.jspCan the GSS support the jsp files as a keepalive?If web server using siteminder for authentication will the GSS be able to do an HTTP-Head test? If not is there a work around?
We have a stub network that we want to install behind a pix 501. We would like to make any inbound traffic coming from that subnet to be authenticated against our Cisco ACS server. Is this possible? How do I do it?Stub-a --- Stub RTR --- Pix501 -- RT...
I have the following networkOutside IP Address 1.1.1.1Inside IP Address 2.2.2.2No I am using PAT for internet usuage. I plan on doing a Site-to-site ipsec vpn tunnel. I want to hide the inside network 2.2.2.0 from the remote network 3.3.3.0. But all...
10.10.2.x -> L3 switch (10.10.1.1) -> (10.10.1.5 - inside interface) ASA ( 10.10.1.5 - outside interface) - server 10.10.1.10I can confirm by looking at the traffic logs on the ASA
I agree but when we connect the ASA 10.10.1.5 to the switch all traffic for 10.10.1.x is being routed to it including traffic for10.10.1.y What would cause this?
