About michaelflood

michaelflood · 09-20-2023

Hello,I'm trying to setup my ucs E series server to accept a trunk connection through the internal interfaces on the router. I followed the "Getting Started" guide and I'm not having much luck. I'm trying to use ucse1/0/1 as my interface for trunking...

michaelflood · 09-14-2023

Hello, Is there a way to convert a routed port to a switchport on an ISR 4000 series router? I tried a few different workarounds but haven’t had any luck. thanks for any help!

michaelflood · 09-21-2023

I have the modules, I need to bridge the L2 modules to the L3 ports so I have 1 broadcast domain. Using a BDI I'm able to bridge the routed ports and even the UCSE ports together, but I'm not able to bridge the L2 ports to that domain. I tried settin...

michaelflood · 09-21-2023

Hey, thanks for the reply! I followed that document before posting here, come to find out... the ole "no shut" was needed on the BDI interface.Do you know if it's possible to add an SVI under the BDI? I'm trying to ideally have all my layer 2 ports o...

michaelflood · 09-14-2023

I currently have 2 layer switch modules installed on the router, and I’m hoping to use the 2 SFP ports on the router ( g0/0/0 and g0/0/2) as layer 2 ports… to be connected to the same broadcast domain as my modules. This is because I have media restr...

michaelflood · 09-14-2023

I tried using encapsulation and setting one of the vlans as native, but no luck.

Member Since	‎09-14-2023 07:01 AM
Date Last Visited	‎10-12-2023 03:16 PM
Posts	6

User Statistics

User Activity

UCS E Series - Trunk setup

Issue with ISR 4000 series routed port

Re: Issue with ISR 4000 series routed port

Re: UCS E Series - Trunk setup

Re: Issue with ISR 4000 series routed port

Re: Issue with ISR 4000 series routed port