Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have had an HP 7000 Chassis with two vConnect modules configured for LACP. There are 4 connections for each vConnect module, two to each switch. This has worked great up until a few weeks ago. We migrated a vlan gateway into the fabric that a f...
Hello, I was hoping someone could help me figure out an uplink issue. I have a Nexus 3524 at the core of the network running 6.0(2)A4(4) code. When I connect a Catalyst 2960x via SFP-10G-SR or LR (fiber connection) I get the following issu...
Hello, I was hoping someone could help me figure out an uplink issue. I have a Nexus 3524 at the core of the network running 6.0(2)A4(4) code. When I connect a Catalyst 2960x via SFP-10G-SR or LR (fiber connection) I get the following issu...
ok, We will continue working with TAC to identify the root cause of the epmlearn fault. I was just hoping someone has ran into this before and knows where to look.
We have attempted to disable and re-enable the ports and the port-channel. It errdisabled immediately when attempting that. Again, The ports are STILL physically disconnected while doing this and the error remains. We would like to get the fault cl...
We have been instructed to have the physical blades set up with Active Standby connections to the vConnect modules with Address hash as the LB method. The strange thing is that the ports have been physically uncabled and the fault still persist.
