Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello - I need some help with fine tuning FCIP between MDS switch to MDS switch.We have 2 x cisco MDS 9222i ("4x1GE IPS, 18x1/2/4Gbps FC/Sup2") one at production other at DR.Both datacentres are connected with dedicated point-to-point with 10 Gbps f...
Hi I have a problem between UCS FI and MDS switch port-channel. When MDS-A is powered down the port-channel fails but UCS blade vHBA does not detect the failure of the port-chanel on UCS-FI and leaves the vHBA online. However, if there is no port-cha...
Hi I am not sure what I am doing wrong but I cannot get VNX 5700 MirrorView initiators to register, kind of lost. Here is the setup.Got three data centre and each have two MDS switches (A & B) with VNX 5700 storage system.Got set up like this to keep...
HelloI am need of some help to get Nexus 1000V working in my lab. Lab is made out of (see attached diagram) and also included screenshot of DVS within vCenter server.Physical server runing VMware ESXi 4.1 - this is standalon server. runinng following...
Hey dakester,Firstly thank you for finding the field notice. Performed upgrade on one of the switch to version 5.0(8) tonight which went fine. After the upgrade I was able to perform fcping and was geting respone. However, still was having problem wi...
Thanks dakester. Confirm have the same part number installed with HW version being 1.0 and software 5.0(1a). Do you know what is the latest version or stable version I should be installing?
Got set up like this to keep it simple setup for MDS Switch AProd Source (VSAN100) –> DR 1 Target (VSAN300) Prod Source (VSAN100) –> DR 2 Target (VSAN103)IVRZones_Prod_to_DR1 are as follow:Prod PWWN (vSAN 100) --> DR 1 PWWN (vSAN300) via transit vSAN...
Thanks Ricardo Septien. Here is the output. PROD Switch Output MDS-Ashow interface brief | in fcipfcip2 150 auto on trunking TE 1 GigabitEthernet1/1 port-channel 10fcip3 150 auto on trunking TE 2 GigabitEthernet1/2 ...
Found the problem - VEM is now listed within VSM along with ESXi host names.root of the problem was - ESXi 5 host (running as virtual machine) server vmnic cannot be in trunk mode and has to be in access mode. Due to the limitation of the my lab setu...
