Hello everyone,I have a query regarding SNMP expressions on my Cisco switch (9300L Layer 3). I recently created new expressions using the following commands:snmp mib expression owner Tunnel10 name destinationexpression 192.168.1.26Now, when I perform...

I have used the EEM commands to create an OID dynamically for my tunnels to be able to monitor them. The commands are provided by Dan Frey (CISCO EMPLOYEE) where I started a conversation in the community (HERE IS THE LINK TO THE TOPIC)event manager a...

Hello Cisco Community,I hope you are all doing well. I recently acquired a Cisco 9300L-48T-4G-E switch for my network, and I'm facing an issue related to SNMP monitoring. Specifically, the switch does not seem to support the IP-TUNNEL-MIB, which is c...