Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Am trying the following command on ASA 8.61, however it appears the static command no longer works. Would appreciate any insights.static (inside,outside) 10.25.0.1 10.25.0.1 netmask 255.255.240.0Thanks.
Configured my 4000 for a second vlan. Fa 5/18 is in vlan 2. Would like a managment workstation and server to be available in both vlan 1 and vlan 2. How can this be done?
Here is the output of debug chcprelay packet:ciscoasa# debug dhcprelay packetdebug dhcprelay packet enabled at level 1ciscoasa# DHCPRA: relay binding found for client 6431.5095.432c.DHCPD: setting giaddr to 10.25.0.1.dhcpd_forward_request: request f...
Did as above with exception of , no nat-control.following was the output when i tried:ciscoasa(config)# no natERROR: % Incomplete commandciscoasa(config)# nat ?configure mode commands/options: ( Open parenthesis for (,) ...
Here is the running-config:ciscoasa#ciscoasa# show running-config: Saved:ASA Version 8.6(1)!hostname ciscoasaenable password ibqCJZNHhOXYLjS3 encryptedpasswd 2KFQnbNIdI.2KYOU encryptednames!interface GigabitEthernet0/0 nameif outside security-level ...
Thanks for your continued attention.The configuration you suggest was our original configuration: dhcprelay server 165.234.128.9 outsidedhcprelay enable insidedhcprelay setroute inside However we are unable to get an ip address on the client.We did ...
