Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I have 5505 firewall, with security plus license. I configure Remote VPN on firewall through CLI with below commands. Remote VPN is working fine , but the problem is, it allow all the users for Remote VPN. I need to restrict few users from a...
Hi there,I have ASA 5505 Firewall with security plus license, I configured two VLAN 1 and VLAN 5 as my inside VLAN for different subnet, i need to route the traffic between this two VLANs through ASA.I configuredint vlan 1nameif insideSecurity level ...
Hi there,I have 1200 AP, for some reason its radio interface led blinks red all the time. So i upgarded to version c1200-k9w7-tar.123-8.JEE.tarStill no luck. One thing i notice is in my GUI radio interface didnt shown up. In interface tab i can see o...
Hi there,I have Cisco ASA 5505 Firewall with security plus license. I want to Configure 3 different subnet for inside network 10.1.x.x, 10.2.x.x and 10.3.x.xSo any PC from 10.1.x.x should be able to ping 10.2.x.x So my question is that possible with...
Hello everone,I have UC 520 with two FXO card, I have 5 PSTN lines connected to that FXO port. The problem is i am not able to see the caller id for incoming calls.As call comes in i can see the name and number it stays there for 2 seconds, becomes a...
Hi there,I had same problem with my UC 520. This happens because when your provider try to send caller-id on UC, UC not able to catch the caller-id. By default caller-id alerting ring set to 1 which is not sufficient in your case. Try following thro...
Hi, thereYes the route which i used is only reference, in real i am using different IP address. I removed global (backup) 2 0.0.0.0 0.0.0.0Yes from firewall i am able to ping 4.2.2.2, and able to access internet from 172.16.100.x subnet.The only prob...
Hi there,Please find the attachment of my current config, i applied the commands but no luck, i disable the no-natcontrol still no luck. Can you suggest other option, packet has been denided byPhase: 7Type: NATSubtype:Result: DROPConfig:nat (camera)...
Hi there,After applied below commands both subnet can ping eachother,VLAN 1 Inside NetworkVLAN 5 Camera Network I need both VLAN 1 and VLAN 5 Should talk to each other, and its working the only problem is VLAN 5 subnet host not able to access interne...
