Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I am trying to setup the IPPA service for IP Phones using UCCX 5. I went through all the steps but when I tried to use the service i got the following error : "Cannot connect to the IP Phone Agent service". I past the service url in my browse...
Hi everyone,I got two questions about CCME.1. the directory entries defined under the telephony-service are accessible to everybody who has an IP Phone. Is there any solution to make private directory entries for each IP Phone so that IP Phone does n...
Hi everyone,I got two questions about CCME.1. the directory entries defined under the telephony-service are accessible to everybody who has an IP Phone. Is there any solution to make private directory entries for each IP Phone so that IP Phone does n...
Hi,I've got a centralized deployment with CCM6 and two sites. I used two H.323 gateways and set the PSTN access code to 9. I defined my route pattern and put my gateways in a route list. My problem is that I've got most of the calls from site B route...
Hi,I've got a centralized deployment with CCM6 and two sites. I used two H.323 gateways and set the PSTN access code to 9. I defined my route pattern and put my gateways in a route list. My problem is that I've got most of the calls from site B route...
Hi Nick,I've got the ip unnumbred interface with no ip address on it. In fact I think my problem started when I went through a software upgrade using the boot helper. My upgrade worked but i ve got this problem.I solved this problem by assigning an I...