Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. We have a Switch Catalyst 3560 as the hub of our net One of its ports is connected to a Gateway, that we don't administer. When we connect a new computer to the switch, there is times that you can connect to this equipment from outside until that...
Hi.We have a Switch Catalyst 3560 as the hub of our net One of its ports is connected to a Gateway, that we don't administer.When we connect a new computer to the switch, there is times that you can connect to this equipment from outside until that y...
Hi.Do anyone know if Switches Catalyst 3560 have any problem with ARP when the interfaces are connected to network cards with more than a network address??Thanks.
Hi.I have a network connected to two Switches, and each Switch connected to the same two Routers. Those are the gateway to the outside. There isn't any routing protocol configured in the routers, only static routes. The interface of the routers conne...
Hi.Now I have a VPN between two routers Cisco through internet to connect two locations (A and B).I want to put other router in location A and create other VPN to the same router of location B and then balanced the traffic between the two VPNs. Is it...
Ok.I am going to try to explain it better.When the PC want to go out it is as you said, but when the router is the one that needs to reach the PC and it hasn't a match in the ARP table, there is sometimes that the router doesn't find the PC. I don't ...
>I would suggest you to set up 2x GRE over IPSec tunnels.Can I use Site-to-site VPN??>Use 2 separate physical interfaces on the router in location B so you avoid a single point of failure (though the router B itself will be a single point of failure)...
I tried it, but I couldn't enter.All the information that I found said that the router mustn't ask me anything if I reseted it to factory values.Anyone can help me??Kinai.
