Hi All,I have configured a switchport vlan on a cisco router for my DMZ (to host my Exchange 2007 Edge Transport server)below: !interface Vlan5 description DMZ VLAN ip address 192.168.5.1 255.255.255.0 ip nat inside ip virtual-reassemblyQuestions:1)I...
Hi,I have just created some switchport vlans to segment my user, server etc....Please what do I need to do for my user vlan to communicate with my server vlan?Thanks all
Hi All, I have just configure an ADSL interface on a router to dynamically connect to BT network for internet connection. Below is my running config: ! interface ATM0/1/0 no ip address no atm ilmi-keepalive dsl operating-mode auto pvc 0/38 dialer poo...
Hi All,I have just configure an ADSL interface on a router to dynamically connect to BT network for internet connection.Below is my running config:!interface ATM0/1/0 no ip address no atm ilmi-keepalive dsl operating-mode auto pvc 0/38 dialer pool-m...
I want to replace a BT Internet modem with a cisco 2811 ADSL ISR.Please what information do I need to get from BT to successfully configure the ADSL router.Regards
Thanks John,Just to further inform you of my condition below:1) My dialer is dynamically (negotiated)configured2) I have range (4) of IP Address from my ISPThanks once again
Thanks John,My NAT source is defined thus:ip nat inside source list 100 interface Dialer1 overload!I can surely get on the internet from the vlan.Hence the NAT is working.Can you link me to an example ACL configured for this purpose?Thanks
Thank you all. I very much appreciate all your help.I have now changed the list toaccess-list 100 permit ip 192.168.0.0 0.0.255.255 any I will give it a go and inform you what happen.Regards to you all,