Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi Ricardo,As Michael pointed out, your burst size in CAR (rate-limit) is very low. If the burst size is too low, the achieved rate will be smaller than the configured rate.Another point is, the equivalent of CAR is MQC police and not shape.http://ww...
Sarah,Yes ofcourse, since this is applied on Sw2 and H1,H2 exists on SW1, they both can communicate.With the above VLAN-access map, H1 cannot access any other hosts in VLAN 1 on SW2 (including S1).Lejoe
Sarah,Now if i configure the vacl on sw1, all traffic from h1 will be dropped, h1 can not communicate with server but it can not communicate with h2 as well. It should only deny traffic between H1 and SW1, i.e H1 should be able to communicate with ot...
