Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Rm,Please go through the below config R1---------------------Router Eigrp 101Network 1.0.0.0 Router bgp 123neighbor remote-as 250 ###As per the digram (eBGP)bgp log-neighbor-changesneighbor [External_peer] soft-reconfiguration inboundneighbor p...
Hi ..Is the link between the Router and Switch Layer 3 or Layer 2?Is the link between the the Switches Layer 3 or Layer 2?meanwhile I will go through configuration and let you know the changes has to be done..RegardsRahul
Hi friend,Then R forms EIGRP neigborship with S1,S1 forms neighborship with R1 and S2,S2 froms neighborship with R2 and S1 and R2 forms neighborship with only S2 as R1 and R2 are not directly connected.(assume that Routed Port has been configured for...
Hiyes...the neighborship will be formedTo build EIGRP neighbor ship the neighbors should be directly connected and should be in the same network.I have a few queries 1.Should EIGRP enabled on all devices (R1,R2,S1 and S2)2.Have you configured iBGP be...
