Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of our customer's is running CatC version 2.3.7.10.70209.10 but they are still getting no data on the last seen column when generating a report based on data for the last 7 days. Based on this Cisco bug this was fixed, or am I understanding this ...
Hello,We want to upgrade our customer's Nexus 9300 switches using ISSU but according to the Cisco documentation LACP timers set to fast rate is not supported for ISSU upgrades. The Cisco documentation for Catalyst Center Appliance installation says t...
Hello,We have configured our cEdge router (C1121X-8P) to act as a DHCP server.We have a DHCP scope configured on VLAN104 which is a SVI interface for the clients WIFI users. The Viptela edge router is not handing IP addresses however we are seeing DH...
I configured the below basic MPLS core network on CML but when I try to enable MPLS on the interfaces within the MPLS core it is not being enabled. When I do a "sh mpls interface" or "sh mpls ldp neighbors" I don't get any output. R1
hostname R1
int ...
Yes our DNAC/CatC is connected to a Nexus 9300 VPC pair.I agree with what you are saying but the issue is that the have VPC orphan ports so the devices/hosts connected to those ports will be impacted.
The customer has a 3 node deployment and in the LAB we setup a 1 node deployment for testing. To see if we can configure the LACP rate on the DNAC appliance enterprise ports. So far no luck.
