Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I updated my Cisco UCS M220 M5 and after upgrade , I cannot reach the CIMC interface again, I have severally changed the IP address of the CIMC through F8 (CIMC setup) still yet , I cannot reach it again. please advice... Can I use the Cisco-Huu apps...
I have tried this suggestion @Nithin Eluvathingal gave and also went ahead to remove the CMOS battery, still I am unable to ping or even reach the the CIMC platform. Please if I reset to FACTORY defaults using Cisco Huu , will I loose my virtual mach...
Thank you Ms Elliot,I was actually using it as dedicated on port 1 (10G) and i got all the good time before the firmware update. I have installed all my virtual machine and all is fine, but then I updated the firmware because last update was old. ple...
