Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I need an immediate solution if possible...I have converted catos to ios in one of our 6500 switch one hr back. After that two of the modules are not coming up..(10,12).I can not powerup the machine at the moment in order to troubleshoot ...
hi,when i use mozilla for accessing webvpn im getting the below error"The installer was not able to start the Cisco SSL VPN Client. Please contact your IT administrator for more information."1. ASA Version: 7.1.12. Webvpn version: 1.1.4.176It works w...
Hi everyone,I have two pix525's HA mode. I tried migrating the same to another vendor firewall, but due to some reasons I could not make it thru. Now, once i reverted back to the pix setup, i found none of the traffic is passing thru the primary fire...
Thanks sir,2 questions-1: IOS 6516 chassis supports WS-CAC-2500W or need higher like WS-CAC-6000W.2:module 9 and 10 are same, then 10 also should come up. So would ios become an issue?-John
Hi,Thnks sir,This is a workaround to combine both PSs and give enough power to modules..But could you tell who exactly is the curlprit.Can you check module 10 and 12...
1.Try disabling turbo ACL in pix.2.Ensure that no High CPU in f/w3.Check no multiple connections in "show conn"4.Ensure that half open sessions are getting timedout..."show timeout" & "show conn | i ssA".5. In serial Cable based f/o, failover will no...
