Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All I have already implemented an IP SLA probe on my network because I need it badly to measure the voice performance (jitter and delay and packet loss…).I used UDP jitter operation with the below configuration to measure the voice performance E...
i have the attached topology implemented without the new server. and i need to add the new server to the network in diffrent site, the new server uses X25/LLc/Ethernet technology and the old connection between server 1 and server 2 are Xot.any one ha...
Hi Giuslar Yes you are write the C3845 does not have the STM4 or even the STM1 interfaces, I am using it as shadow router connected just beside my voice equipment (soft switch-media gateway) and the remote responder router is also dedicated for SLA a...
Hi hcintronOne more point should be taken in consecration.You have to create proper filtering for the routes sent from your routers, only advertise your range of addresses. I mean don't rely on your service provider to filter the routes that came fro...
I think you are performing a wrong test you are trying to ping 172.16.1.1 which is an inside-global Ip address only configured in the nat pool, so there is no destination with this IP to respond to the ICMPBut if you tried to reach the inside local I...
Dear AllI found a better and easer solution to be used in this topology,I will enable the CMSN under the Ethernet interface that faces the new server, and on the same Box I will enable X.25 routing and configure x.25 routes (XOT) to route the x25 tra...
