Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.
I have two questions about ICMP behavior and Fregmansion behavior.
All system jumbo MTU / all interfaces / SVI are set to MTU 9216.
1. Packets are generated and processed by the ASIC (data plane) when pinged without a source
When pinged to the...
If you look at the bug, it's been shared as a phenomenon since version 10.2(4), and now it's showing a bug-like phenomenon in 9.2(3) equipment.Is this the bug that only comes out after 10.2(4)?
It was just a simple question. I don't think there will be any future tests with timeout 0, so I think I can end the question here. Thank you so much for your help.
bfd interval 300 min_rx 300 multiplier 3bfd multihop interval 300 min_rx 300 multiplier 3
BFD settings are as above.
When I was doing the test I tried to ping timeout 1 count 10000 with x.x.x.x.x.x packet size 40000, but I set the timeout setting inc...
There was a bgp loop phenomenon in the current network, so we did an icmp test by increasing the packet-size. I set the packet-size to the maximum value and did a ping test, and all the bfd session was cut off on the equipment, causing a bgp flap phe...
