Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello communitylately after upgrading my ISR 4331 router IOS this syslog message appear and cause the router to reload%SPA_OIR-3-SW_INIT_TIMEOUT: subslot 0/5: SPA initialization not completed-Traceback= 1#b29b2857b4051a30c665fc71d8fa5182 :55D4BEEA300...
Hello community,I recently attempted to upgrade my ISR router to the latest version but encountered an error stating:"Failed to boot file bootflash:isr4300-universalk9.16.09.06.SPA.bin"This occurred despite entering the correct commands.The current v...
Hello all
I am currently facing a problem when trying to remove the switch from the stack, as I tried all the commands but it still does not switch to standalone mode.
When the switch is restarted, it goes to the elections and config is lost....is...
Hello M02@rt37 Thank you indeed. That was the solution. I checked the copy (md5) and it did not match the one on the Cisco website. Now I have to submit a memo to my direct manager to verify the source of this copy.I have already been able to downloa...
after initiating factory-reset allthe switch rebooted and enter into ROMMON mode asked me to provide new IOS.bin .... after fleshing the new IOS the switch boot processes started and it shows me the same STACKMGR-6-STACK_LINK_CHANGE: Switch 1 R0/0: ...
no, the switch disconnected from the stack a month ago ... and the admin at this time but it in reserve but now i wont to use it as standalone SW ... i tried switch clear stack-mode but after reload its back to stack config... again