Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm trying to configure a NTP server on Cisco FMC (6.3.0).
FMC is running on my VMware fusion.
NTP server is running on a ubuntu VM.
They both have connectivity, ping was tested.
But the NTP server of ubuntu is not being used rather the FMC ...
Hello,
I'm trying to setup a FTD and FMC on my VMware Fusion with the MAC being the host.
The FTD was added to my FMC successfully. But i ended up getting time synchronisation errors.
Can you please tell me how do I set up a NTP server on my MAC an...
Hey,
I am trying to setup ASA clustering.
I need to setup port-channels between the ASA and the switch on both the inside and outside of the ASA.
The clustering works alright on the ASA. The master and the slave come up perfectly.
But when I ad...
Hi experts,I'm a newbie with decent knowledge of NSO and would want to understand if NSO can be used to perform a device upgrade .eg: A CRS router running 5.1.3 has to be upgraded to 5.3.4.Can you please direct me to any resources in this regard or p...
Hi Experts,I'm pretty new to NSO and wanted to know if there exists any SNMP southbound support for NSO so that I could fetch device data using SNMP mibs?-RegardsJoyal mendonca
Hey Kasun,
Both my FTD and FMC are running 6.0.1.
From what I understand FTD has to be configured from FMC.
So can you show me a quick example on how to setup NTP servers on both of them or maybe direct me to any documentation available on this.
...
Hey, Following is the config.
SW
interface range e 1/1switchport hostswitchport access vlan 10
interface range e 0/2 , e 0/3channel-group 10 mode activeno shut
Interface port-channel 10switchport mode accessswitchport access vlan 10
interface r...
