Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,
I'm trying to configure a syslog server to send all my logs through the server on the port 41515 for example.
But, I don't see the option to set the port on the command "logging server".
Someone knows if this option has been decommissio...
Someone has any ideia?
I have 2 N5K peers and 1 N7K peer in my Datacenter. The N7K is Switch Core and both N5K peers connected to it by VPC that I´ll call them (AB-01/AB-02) and (DE-01/DE-02).
I have 4 servers in the N5K peer DE-01/DE-02 that works f...
Hello, It´s my first topic and I have a hard issue related with Cisco ACE.We have a configuration load balancing a URL in the port 80 with no problems, but, with the port 443 is not working.Both the probe, serverfarm and realservers are OK (active) b...
Hello for everyone.
The problem was the new server had been configured with the MTU 9000 in the interface, and the other servers were configured with MTU 1500.
Hugs.
Hello David, Thanks for the advice.
I had done it before but here is the output. It don´t show nothing:
AB-01# sh ip igmp snooping groups vlan 2535Type: S - Static, D - Dynamic, R - Router portVlan Group Address Ver Type Port listAB-01#
AB-02...
Hi Ana,
In the Cisco document, they says that if you disabled the IGMP, it would work as broadcast traffic in the solution 5.
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/68131-cat-multicast-prob.html
Hello Tim, we solved the problem the last wekeend. The problme was the certificate that we had to pass to ACE, so we took out the certificate in the Apache server and download to ACE. Thanks at all.
