Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,Inside is on gigabitEthernet0/1 ip 192.9.200.254I have a dmz on gigabitEthernet2 ip 192.168.100.254I need to pass port 443 from outside to dmz ip 192.168.100.80 and open port 1433 from 192.168.100.80 to the inside network. I believe th...
Hello all,I am attempting to set up an Anyconnect VPN on our 5512. Most of the examples I find online have some type of error or depreciated command in them. Could someone please show me a working command line example the allows the VPN to connect AN...
Hello Everyone...I was wondering if anyone could help translate these old NAT commands to the new NAT commands for a 5512-x ASA.I guess I am having trouble wrapping my head around the whole thing and I don't program enough routers to really retain an...
I have an RV042. I understand and have created the services I need. The documentation is just not clear on how to direct traffic for these services to a specific wan port. Can this even be done with this router? If so, the how? Use rate control or pr...
I just put the security level at 100 to get the port going. I will gladly change it to 50. I don't want all traffic between the dmz and inside, just port 1433.Thanks,John
It's working great! However.... I provided the information to the people needing the VPN. They say that it needs to be a Cisco connect VPN not Anyconnect. Is there such a thing? All I can find is a reference to EZVPN which seems to have been phased o...
When I get to this line I get an error:group-policy SSLVPN attributes ^ Invalid input detected at '^' marker. (It's under the a in attributes) Thansk again,John
Thanks!! Do I need to do anything with certificates? Just add users and it's ready?Does this look right?username vpnuser password VpnuserPasswordusername vpnuser attributesservice-type remote-access Thanks again for your help,John
