Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,I am currently using a UC540W and have it setup to ring the Blast group and then transfer to Voice Mail.Sip Provider is VoIP-UnlimitedI have configured the prefered codec to G729r8, and allowed transcoding. Everything was working well untill, I ...
Hi I have tried this both creating my own config and also using cisco cp and both have left me scratching my head for a few days.I have tried a similar basic config on a cisco 1861srst router and it works fine but I am having problems with the C881In...
HI,I am looking for a little help with this all input is welcome.I have a UC540W and a number of endpoints all are 79xx series using sccp. only one is a 9971 sip handset.I have configured the unit using the Cisco configuration assistant version 3.2, ...
Hi,I have been having issues with routers and ADSL Modems for some time with the UC320,Some of which I have TriedDraytek VIgor 120Draytek Vigor 2600Zyxel P660Netgear DS834Gv3, DS834Gv4, DS834Gv5Linksys WAG354GOnly some of which I have tried, but all ...
Hi I have been running my UC320 with out fault for a while but the call forwarding fuction has stopped working correctlyIf I put call forwarding on to call my mobile number and then call the DID Sip line number for that extention it drops the call wi...
Hi Today I have removed the DDI's from the sip trunk and removed the firewall. and testedWhen you call the main number now you get the 140 ringing tone. ()when called from my EE mobile)I have added in a new firewall (ACL firewall) to the UC540 and it...
Hi Leslie,I too have a UC320W and it now gathers dust on a shelf. a great idea on paper but was never ready for market.Unfortunatly as far as I knwo Cisco have pulled out of the Small Business sector and have sold off part of the company to Belkin.Th...
HI Carlo,Many Thanks for your reply I pulled an allnighter last night as this was doing my head in, Finally recreated the config and got it working. the config is below. the only issue i am having is when I place a call from CUCM to the sip trunk t...
Hi John,Thanks for that I think it'll be an ACL Issue. I don't fully understand the acl so I have basic routing but never setup the acl. so I'll have to learn a little bit.cheersAlan
Hi Andy Thanks for the post I am interested to have a look at the doc can you repost the link? When we got the router it only supported pppoe in bridged mode and not pppoa which was a pain Iam now using a uc540 and a draytek vigor 120 to bridge pppoe...
