Hi all,Just wanting to get some advice as to the best practice or preferred method for DHCP Pool Scope configuration for IP address leasing.Should I have an AD (Active Directory) integrated DHCP Scope or configure my Cisco router to allocate IP addre...

Hi all,I am having plenty of trouble trying to get my network connecting to the internet via a 2621XM router.I currently have my network connecting to the internet through an ISA Firewall/Proxy but am wanting to replace this with the 2621XM.The route...

Hi all,I am having plenty of trouble trying to get my network connecting to the internet via a 2621XM router.I currently have my network connecting to the internet through an ISA Firewall/Proxy but am wanting to replace this with the 2621XM.The route...

I have a 2621XM router and was wanting to use it as a NAT/firewall for my network and was wanting to know how I should go about configuring it to achieve this.FE0/0 is the outside interface, configured as 10.1.1.254 and is connected to my ADSL modem....

I have recently purchased a used 2621XM router and have found that when I turn off or discconnect the power, the config is not retained.... and before you ask, yes, I have saved the config from running to startup.The only change that I have done afte...