Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to set up a QoS policy-map on a Cisco 9300L that replaced an existing Juniper QoS policy. Ideally I want to match it exactly but I'm running into a basic difference between the two. Many of the Juniper policies have a transmit-rate and sha...
I have a device that is sending data to another. It passes from the sender, through a one-way data diode, into a Cisco 6509, accross a data trunk to a Juniper EX4300, then out and through another one-way data diode before finally getting to the recei...
We're attempting to route T1 traffic into a T1 card in an ISR4451 router, to another ISR4451, and out a T1 card installed there. Currently it's just the two IRS4451 devices directly connected by a Cat6 cale. We've tried following the process of encap...
My instinct is that a multicast setting set up for another VLAN or globally is affecting the system but I can't find anything obvious.Regardless, VLAN, Port, System, and IOS details attached.
Oops, I just realized I had the two ISR's backwards. The setup is as followsFluke -> T1 Card -> GigEth0/0/1 -> GigEth0/0/1 -> T1 Card -> Loop | ISR 1 | ISR 2 |So yes, ISR 2 does ha...
While I agree it's not the best way, it's unfortunately the situation I've been handed to try and solve. We have Juniper CTP151 devices in other locations doing the same process, but we're trying to find Cisco equipment that can do it as we're a pred...
