Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running Symbol Barcode scanners on a WLC4402 + 1131's running 4.2.207.0. The WLAN is currently open for testing purposes. The guns associate and are placed in a run state on the WLC and sees that the station has an IP address, however you cannot ping...
Is there a way for a client on one autonomous AP in user vlan A to roam to second autonomous AP in user vlan B whilst retaining IP address without using WDS. So Mobile IP Layer 3 roaming possibly through the switch/router?The two APs are connected to...
If you have two autonomous AP's, both with the same user vlan and subnet, is there a way to block users from one AP communicating with users on the second AP.I know you can use PSPF for users connected to the same AP but need the best way to stop the...
I know, this is what is driving me insane. If you try to ping that client from the WLC it fails. As soon as you swap the WLC for a Fat AP with basic config it just works.
Clients are auth and RUN so as far as the WLC is concerned, it would appear it is happy for the client to pass traffic but it doesn't. It's driving me insane!
just to add more into the mix. The user VLAN will be layer 3 so presumably the users will be able to communicate via the SVI? Can you use an ACL to prevent users in the same vlan communicating or will I need to move over to Private VLANs?Also there w...
Thanks Rob that is exactly what I was looking for. Following the link I am quickly realising that I am being lazy and should have read through the config guide before posting -5 points to me!
