Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I have the following topology. Network A needs to talk to Network B.I created Customer VRF on the middle PE (PE-X) and I successfully saw the routes from both sides, however Network A still cannot ping network B. also, traceroute show...
I am confused of router license output. show version shows the following output. So, can i use IPsec?what does it mean that Suit is permanent and Package is none?
hello everybody,
i am using GNS3 1.4.5 .. IOU image to create a simple MPLS lab.
routes are propagated via OSPF and pingable, but show mpls forwarding-table gives me below output.
P-11#show mpls forwarding-table Local Outgoing Prefix ...
hello everyone,it is long time and i think that CIDR is just a routing method that allows routers reduce routing table size.tonight, i was reading a book mentioning that CIDR saves address space.This makes sense of what follows:assume your organizati...
hello everyone,I am studying my first lessons on CCNP. I started with EIGRP and now configuring it over a Frame-Relay network.Platform: three c3660 routers in GNS3 environmentTopology: Hub-and-SpokeStrategy: Multipoint with sub-interface s1/0.1 confi...
Actually, it is a classified information that i cannot expose without customer permission. However, I will establish a lab with c7200 routers to simulate the case and post the configuration.I am sure, c7200 will work correctly, as the problem is betw...
LDP sessions between PE-1 and PE-x AND PE-2 and PE-x are up for weeks. Actually, this is not the first abnormal behavior between Nexus and ASR.I have very strange cases. For example, BGP will never install routes in the routing table unless the bgp n...
@Harold Ritter wrote:You do not need to enable "address-family ipv4 vrf Customer" on PE-X, unless there are actually local customers belonging to that VRF.Yes, and that is why I am asking for explanation. On the other hand, Do you have a direct VPNv4...
Thank you Harold.Yes, I am sure of the ping's source.and Yes, I mean enabling "address-family ipv4 vrf Customer" on PE-X.By the way, it is not a router.PE-1 is an ASRPE-2 and PE-X is a nexus N7K. So, the correct syntax is:router bgp 65000
vrf Custom...
