Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Can someone to explain the EIGRP metric why using BW with floating point to multiply 256? As I knew we should rounded the floating point to integer. BW = (10000000/30000) * 256 = 333.33333333333333333333333333333 *256#rounded the BW to 333, ...
Hi all, Can some one help me out and expalain this calculation with wrong metric output? is it a bug?Show eigrp topology 6.0.0.0/8 with following BW and Delay for EIGRP metric calculationMinimun bandwidth = 30000 KbitTotal Delay = 1130 microseconds C...
Hi all,I have do the vlan based qos on multiple platform (3560, 3750, 4000, 4500) and found even i do not use "mls qos vlan-based" on switchport but only on the SVI, it also work fine for dcsp marking, any idea to this command? Or it is only use for ...
Hi all,We are setting up a lab for testing LAP as a 802.1x supplicant between switch which using WLC 6.0.188, since we don't have ACS, so the question is can we use the WLC local EAP for the AP 802.1x authentication? Or there is way to make MS server...
I have received this message from WCS and the ap's radio interfaces were down and then disassociate the WLC, and ap did not up again, but there are no clients and not many ap near,what happen?
1. Check any public IP NAT mapping to switch address.2. Check the USG firewall session table by "display firewall session table verbose destination inside <IP address>, to check anyone SSH to your network
