Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Does anybody know whether there are plans to add FirePower NGFWv image to CML-PE/VIRL? At the moment there is only ASAv made available. Thanks in advance.
Hi All,I have a customer who has an existing data centre that does basic server load-balancing using CSS11500's. They are now looking to implement another data centre to give them redundancy and the abaility to load-balance the traffic betweenthe sit...
Hi,I realise this is a slightly older post now but just came across a couple of sections of the RFC which details the behaviour of acknowledgements pretty clearly: -13.5. Sending Link State Acknowledgment packets
Each newly received LSA mus...
Hi RichardDid you manage to succeed with this? I know that you had said you could not use when configuring on a trunk but if you use the 'switchport voice vlan' command to assign the VLAN ID of the Voice VLAN this creates a 'special' dot1q trunk so y...
No problem - not wearing anything out Only reasons for me would be if you had different switch models at the core, perhaps if one switch was on newer hardware, or if one of the switches was significantly more reliable than another etc - I have seen t...
Yes, unless there are specific reasons not to then I prefer to try and load-balance traffic between 2 core switches and your network topology is typical for doing this.Something else you might want to consider is reducing the HSRP times to speed up c...
