Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I successfully authenticate through ACS -->LDAP, but only get dropped into a non-enable prompt: Core1>
How can I get an Authenticated user directly into enable mode?
Let me know if you have any further quetsions.
Thanks!
This ist mein config on A...
Hello Community, i have a problem, one Notebook in our enviroment authenticates successfully with Host-Lookup (MAC-Adress) and get the right VLAN but then also sends permanantly PEAP (EAP-MSCHAPv2) requests with a diffrent Username ( Username is n...
Hello Community, iam using Cisco ACS 5.5. I have a short question,When i want to authenticat a normal Computer with Mac-Address, do i only have to add the Mac-Adress under identity Stores "Hosts" ? When i do that, i see on Reporting that the Computer...
Hello Community,is ist possible to assign a tagged Port after successfull authentification for ip-Phones with username and password ?I got an ip-phone where username and passw0rd is deposited. The authentifications ist successful, ...
Hello Community,iam on the evaluation on Cisco ACS 5.5, and iam trying some scenarios for my company.I have to authenticate a ip phone . here i need one VLan tagged and one vlan untagged.In the authorization profile u can add the R...
Hey, host-lookup ist already activated.. the Problem is the Switch.. the switch is sending CHA/MD5 pakets to the acs...i installed a newer firmware on my hp switches and now it works
Hello, how can i configure my authorization profile to get one tagged vlan and on untagged vlan when i connect my ip-phone ? i want to connect an pc directly to the phone ? so i need one tagged port for voice and one untagged vlan for data. is this p...
