Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have now been troubleshooting for the last couple of days, to get a VPN tunnel (Site - to - Site) up and run again. (it have worked before)
But it is not working what ever I have done.
Reboot the site B router
Taken all configuration down...
Hi,
We have tried to setup a SSL Client and using Anyconnect...on a ASA 5515 running 9.5.2.
Client is connecting fine to the ASA, but it can not Reach server on inside.
From firewall to the server there is Connection and tested.
I have runned the Cis...
Hi,We are trying to get a video conference system (POLYCOM) up running. Thrue a Cisco 1812 router with Firewall feature set.I Have heard in the past that there should be issues with Polycom and Cisco, but have actually never seen it.I can establish...
Hi,We have 2 security context configured on at PIX 525 with 8.0.2.Users on context 1 should be able to reach webservers on context 2I can not see in any logs that the traffic is being blocked, but it is not possible to get to the page.From everywhere...
Hi,I have a setup where I want to block traffic from one side and allow it from the other.10.48.100.0/24 one side of the router (routed via 10.45.1.1) - 10.45.254.0 on the other side.From the 10.48 scope I should only be able to reach 2 IP adresses...
Hi,
There is no NAT at all.
I ran your command, and now "NAT is removed from the debug"
007314: Jan 31 07:06:13 CET: ISAKMP:(0):purging SA., sa=302FE2F0, delme=302FE2F0007315: Jan 31 07:06:13 CET: IPSEC(key_engine): request timer fired: count = ...
Hi,
I will Close this Down again.
I was helping troubleshooting for another Company, and the server we have been testing is not setup correct on the LAN side.
This was one of my first questions, because I was also pretty sure everything was correct...
Hi Varun,Thats fine.Since it is running with one of our customers, and there is no shared support on this.We will try and do a bit of testing on a different router, with the same software.So we agree that there is no easy solution.But I will gladly ...
Hi Varun,I have just got confirmed that we have from day 1. have enable on the polycom that it is going thrue NAT.And before we began to troubleshoot, H323 and H225 was enable on the router. But it still did not work.Polycom told us to remove the H3...
