Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a trunk connection between a CAT4500 and a C2960G-48TC-L.On the C2960 end I get a lot of input errors and the amount is increasing. SFP on the 2960 has been replaced and fiber has been tested and gives no problem.the output of sh int...
Hello,I try to configure a WLC4402 new out of the box. If I make a console connection for initial configuration I see the boot sequence in my terminal software but I am not able to send keyboard commands. the session does not accept keyboard input. I...
Hello,I have the following problem. We are running ADSL at 2 sites with fixed WAN IP's. In both configurations we have the ip route command to forward all traffic to the ISP gateway. Both WAN IP addresses are in the same subnet, so we are not able to...
Thank you all for your assistance. In the end it was a bad patch cable on a patch panel. As usual the only connection that hasn't been replaced ot tested yet.
I had the mtu size on gigabit interfaces set on 9000.switch#sh system mtuSystem MTU size is 1500 bytesSystem Jumbo MTU size is 9000 bytesRouting MTU size is 1500 bytes
I forgot to post the config of the interfaces.CAT4500interface GigabitEthernet1/2 switchport access vlan 100 switchport trunk encapsulation dot1q switchport trunk allowed vlan 1-4093 switchport mode trunk mtu 9000C2960interface GigabitEthernet0/48 sw...