Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have a topology like in the picture. The cameras use PoE.For example, take a real example, I unplugged the fo cable at switch-1 ( Only Te1/0/1), then the IP cam turned off and then turned on again after a while.I want if the cable is removed, ...
HelloI need your help, how to configure this. In the CLI, SFP+ has been detected. Now, how to connect beetween switch? or what command should i enter in CLI?Because it's still down, on the indicator light or port status on the CLI.
Hello, I am Haidar. I am from Indonesia. Nice contacting with you.I have a project from my client. We need a network device. I need help, can you give me what series of Cisco Switch devices I should use with the specifications and topology below (att...
Yes that's correct. The stream & recording of camera was off for almost 1 minutes. No configuration yet. I just set the password and vlan1 to remote the switch. Do you have a solution?
Yes, i am sorry. I mean the power of camera isn't off. But the stream and recording of camera is off. Almost 1 minuteDirect connection between core switches doesn't exist. Should i give it?
