About bulgogi09

bulgogi09 · 08-04-2009

Hello,Attached is my configuration.What I want to have happen is the 192.168.1.x users that originate traffic on the 'interface BVI1' to ping out on the Internet to any IP address.I do not want anyone on the Internet to be able to ping my DHCP addres...

bulgogi09 · 06-18-2009

Hello,We have a blade switch CBS30X0-LANBASE-M that won't sync to NTP nor authenticate to ACS.SW1#show ntp associations detail 172.23.218.187 configured, insane, invalid, unsynced, stratum 16ref ID 0.0.0.0, time 00000000.00000000 (00:00:00.000 GMT Mo...

bulgogi09 · 05-22-2009

Hello,Can someone please explain to me what the '.' in front of these messages mean?May 22 10:17:34.956: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 10205: Neighbor 10.205.3.138 (Tunnel0) is up: new adjacencyMay 22 10:17:41.776: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 102...

bulgogi09 · 08-05-2009

This has been resolved.All that was needed was this:!interface FastEthernet4 ip address dhcp ip access-group deny_in in ip nat outside!!ip nat inside source list 100 interface FastEthernet4 overloadip nat inside source static tcp 192.168.1.10 3389 in...

bulgogi09 · 08-04-2009

chinkevi,That part is easy. But when I do that the ICMP return packets originating from the LAN side are blocked.

bulgogi09 · 06-18-2009

Hello All,I just found out that our HP Blade switch with Cisco modules is only L2 and can't do any L3 routing that is why it is failing.Thanks to everyone for their assistance.

bulgogi09 · 06-18-2009

Hi iyde!Here are the results:SW1#ping 172.23.218.187 source vlan 312Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 172.23.218.187, timeout is 2 seconds:Packet sent with a source address of 172.23.12.20 !!!!!Success rate is 100 percen...

bulgogi09 · 06-18-2009

Here is what is listed in the logs over and over:.Jun 18 08:57:25 GMT: NTP: xmit packet to 172.23.218.187:.Jun 18 08:57:25 GMT: leap 3, mode 3, version 3, stratum 0, ppoll 64.Jun 18 08:57:25 GMT: rtdel 0000 (0.000), rtdsp 10001 (1000.015), refid 00...

Member Since	‎05-22-2009 02:50 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	8

User Statistics

User Activity

ACL assistance

NTP and Tacacs not working

Question on the display of 'show logg'

Re: ACL assistance

Re: ACL assistance

Re: NTP and Tacacs not working

Re: NTP and Tacacs not working

Re: NTP and Tacacs not working