Okay so I have a basic home lab, 2600 router x2 and 2900 XL switch x 2. I've connected each router together (they "see" each other in cdp), and each router to one switch. My problem is that the interfaces that the router connects to the switch won't ...
I'm studying for my ccna, the 2500 router I have will not allow forced ssh input on the vty lines, I know my commands are correct, I'm using a cisco book I got at bootcamp.Can't figure out why it won't let me use ssh only....thanks
It came with a db9, I don't have a db9 port.How else can I get into the console?A rollover won't work.I don't know the hostname of the router, I assume it was factory default?The person I bought the kit off wasn't nice enough to tell me the settings....
yeah dood uhhh wicked embarassing why didn't I think of that, switch is layer 2 LAWL I knew it was something simple I forgot.Okay so I gotta put the switchports in vlans to assign IP addresses... cool thanks for the help. I took a boot camp a few mon...
No, they don't work, POST is fine (The switches boot normally), CABLING IS FINE, they are NOT admin downSwitch1#sho runBuilding configuration...Current configuration:!version 12.0no service padservice timestamps debug uptimeservice timestamps log upt...
The routers are connected via serial 0, so I could do some practice frame-relay config. The routers hook up via Ethernet 0 to the switches Fast 24. (One router per switch.)The switch interfaces will not accept an ip address (the cabling is correct), ...
Okay, that clarified a lot. I assume the routers are at factory settings, so since i cannot enable a telnet password without access, I need to get the db9 adaptor.tydevlin
Okay I'm sorry let me try rephrasing my question."Is there a way to gain console access to a 2500 router WITHOUT a db9 connection.(ethernet to ethernet, usb to ethernet etc)"Thank you,Devlin
