About cebit

cebit · 12-14-2023

Hello, I converted my network from a C350 -24 port to a C9300-48 UXMWith the C350 the WAP 581 run without any problems. On the C9300 I get the following Error Message: NOTE: The 5 GHz radio module was deactivated because the power source is no longer...

cebit · 09-30-2024

Hello, Is a standard route set up? Example: : ip route 0.0.0.0 0.0.0.0 192.168.XXX.XXX Set the X to the corresponding destination address Nat outside and inside set to the interfaces?

cebit · 12-15-2023

I found the error, by chance I came across an old post here in the forum where the same error occurred.The solution is that LLDP must be globally ebabled. In case anyone runs into this issue. LLDP must be enabled globally on the switch and not jus...

cebit · 12-15-2023

Hello,I tried different ports, all with the same resultIt's a single switch.With a 1100 W power supply, a PoE power of approx. 500W can be used on this switch. If more is required, another power supply must be installed, as stated in the technical do...

cebit · 12-14-2023

Port Configuration, all for Ports have the same Config

cebit · 12-14-2023

Hello,The Error occurs on the WAP Access Ports, the Status LED on the WAP also lights up Blue, which results from the error.The ports are:33,34,35 and 36The power supply is a PWR-C1-1100WACbuilt-in.I once tried to manually increase the PoE wattage on...

Member Since	‎12-14-2023 10:15 AM
Date Last Visited	‎09-30-2024 02:25 PM
Posts	6

User Statistics

User Activity

Problem with POE WAP 581 and C9300-48UXM

Re: How to configure C1121 WAN that is downstream from a private netwo

Re: Problem with POE WAP 581 and C9300-48UXM

Re: Problem with POE WAP 581 and C9300-48UXM

Re: Problem with POE WAP 581 and C9300-48UXM

Re: Problem with POE WAP 581 and C9300-48UXM