Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have worked with cisco on this and so far nothing. I have a vip that i cannot communicate over port 80, all configs are good according to cisco. if i telnet to one of the 2 servers behind on port 80 they work fine, If i telnet to the vip on 80 it a...
I have a ASA 5510, we have both IPSEC and SSL setup on it, the users authenticate to a radius box. We would like to find out if there is a way to block users from using the IPSEC client (except for a certain few) and make everyone else use the SSL wh...
kind of sounds like you dont have a bootable image on your flash. have you tried when it comes up to type boot and hit inter? If the image is good it should boot, if it is not you will be returned to the same prompt. I know you have put new ios on th...
do you not have to have a line under the permit line to say deny ip any any logthis should then send the info to be logged, otherwise it is just dropped and not logged
if the guest on the inside are trying to connect to there home vpn device and are using ipsec, The IKE key-negotiation protocol uses UDP port 500, therfore i would suspect the key negotiation would fail. You can also look at the logs on your device a...
if your vpn sessions are using ipsec they use upd for ike, try adding an acl to allow udp into the guest devices only, setup a scope for guest to recieve a certain ip range and allow udp to that see what happens.
"device does not contain a valid magic number"this means the cisco device doesnt recognize the flash device, if you format it while it is in the cisco router then put your image on it you will be fine.
