Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone.I currently have a WLC C9800L running IOS 17.8.1.I just bought 3 x C9120AXI-S (VID 7) and want them to join this controller.I know that with VID 7, it will need to upgrade to AP Version 17.9.2 or later but when I upgrade these APsto that ...
Dear Every One,Currently, according to the attached network diagram, I am experiencing a situation where network devices below the Firewall layer sometimes lose connection to the network (cannot ping the IP addresses of access switches).I checked the...
Hi everyone,I currently have 3 x model AIR-AP1832I-K9 running CAPWAP with WLC2504, due to WLC2504 failure I have switched 1 AP1832I to Mobility Express Firmware 8-10-185 mode.After I completed the transfer, the AP rebooted continuously and did not bo...
Dear @Mark Elsen ,Since the WLC 9800L (17.8.1) is currently managing 11 AIR-2801I-SK9 APs and is running at version 17.8.0.144, this means I cannot keep the WLC version at 17.8.1 if I want 3 C9120AXI-S to join this controller??Thanks!
Dear Ahmedshoaib,I have just rechecked the configuration and want to update you with the information below.The 201F Firewall is operating in HA mode (Active/Passive).The C9300 Switch (Gi1/0/2 and Gi2/0/2) is not configured for Port-Channel but is in ...
Dear Ahmedshoaib,I'm sorry for not taking careful notes, but the red circle shows I am using the port channel on both the switch's and Firewall's.Let me provide more information about Firewall devices, currently, 2 Fortigate 201F Firewalls are config...
Dear Leo,Thank you for your information.Is RMA the only way for this case?Currently, this AP device is out of warranty so an RMA cannot be performed.Thanks!